Garador DR/RM Garage Door Spring

Garador retractable DR / RM springs to suit double garage doors with horizontal tracks running into the garage, and supported by track support straps hanging from the ceiling. When the garage door is opened the door retracts almost fully inside the garage.

The door will have two springs located on either side of the door usually each encased inside a high-impact plastic cover tube. The link arms on DR / RM doors measure 3'9¾" (116cm approx) in length and have three fixing point holes in the top of the arm for the spring anchor pin.

Please see the spring table to determine the spring number required. Alternatively, the spring number was often engraved on one end of the spring.

Important: These springs are not compatible with older Garador "Double Type R" model doors with approx. 660mm (26") long springs. The arms on the older door are 4ft½" (123cm) in length and only have a single hole at the top of the arm for the spring pin. The springs for this door were discontinued some years ago and are obsolete. Repairing this door would require a new garage door mechanism (AP250).

It is always recommended to replace springs in pairs so that the door remains balanced.
Please note: If replacing only one spring, our standard product warranty does not apply. Please see terms and conditions for more information.

How will I know that this is the spring I need?

Your garage door will have two springs located on either side of the garage door. These are usually encased inside a high-impact plastic cover tube which protects the springs. The part number for the spring is usually engraved on one end of the spring but this can be rubbed off due to wear and tear. If you need help identifying the correct part number then our Spring Finder Table accessible by scrolling further down the page can help you.

The link arms for DR/RM Garador garage doors that this spring will fit on are 3’ 9 ¾” in length. They will have three fixing point holes in the top of the arm.

The springs have the following part numbers:

• 108-901
• 108-903
• 108-905
• 108-907
• 108-909
• 108-911
• 108-913
• 108-915
• 108-921
• 108-923
• 108-925
• 108-927

These will be dependent on the garage door which is why we have the tool available below. You can usually find the spring number engraved on one of the ends of the spring itself.

How do I install these springs?

Step-by-step instructions for replacing your garage door spring can be found by clicking the Fitting Instructions tab above, or by clicking here for the PDF version.

The springs should be fitted with the door in the open position, and thick gloves or cloth should be used to protect your hands.

I’m having trouble identifying the correct spring, how can I get in touch?

There are a couple of ways you can choose from in order to contact us, most of our clients always call us at 01704331705. This lets you speak to our customer service team who are experts when it comes to garage doors.

Otherwise you can simply send an email to sales@wsgaragedoorspares.com or send a message to our WhatsApp at 07481342447. If you include images when you do this, it will be very helpful as we can then identify the part much more easily. Don’t hesitate to get in touch and repair your garage door today!